Adhere hook and loop adhesive strips (sewn onto the screen) to sides of your doorjamb. After the installation, check to make sure the rod is tight in the doorjamb. If not, open the rod a little wider. The center opening of the screen should be centered in the doorjamb. Adjust the screen mesh towards the center of the rod. That's all there is to it! Now Bug Off can be removed and replaced in minutes.

Please measure your door before ordering!

Measure the height from the top of the inside jamb to the floor. If you have a wood or metal threshold on the floor, measure from the top of the inside jamb to the top of the threshold on the floor. Bug Off will not close properly if it drags on the floor. The rod will take up the screen about a quarter of an inch, which is necessary for it to open and magnetically snap closed.

If you're installing Bug Off on a sliding glass door, be sure to measure from the top inside of the track, to the top of the bottom track. Bug Off must clear the bottom track to open and close properly.

If your door opens in, install Bug Off on the outside of the door.

If your door opens out, install Bug Off on the inside of the door.

When ordering a custom screen, please give us the exact size of your door opening, where you plan to hang the screen. When we process your order, we will add 2" to the width, to allow the screen to fold into your doorjamb and attach on each side. When measuring the height, measure from the top of the doorjamb down to the highest point of your bottom threshold, or floor plate. Bug Off must swing freely to open and close properly.

Bug Off can close perfect every time!
Simply hold the right side of the screen open a second longer than the left. This will allow the left side to come into position first and allow the right side to snap closed against it.